Pump Skids

01 / 08

A pump skid, as we build it

Length, width and beam sizes follow your pump and motor; this model is one example. What we show is how the steel is cut, welded, machined and checked so the set aligns first time.

Scroll to see how it is built · drag to turn it round

02 / 08

A base that stays flat

Perimeter beams and cross members cut to length, drilled on the beam line and welded in a sequence that keeps the frame flat and square once every bracket is on it.

How is it possible at Allmarc?

Robotic H-beam cutting and bevelling cellBeams up to 1,000 x 500 mm

Used here for: A base that stays flat

• Beams up to 1,000 x 500 mm
• 12 m long, 50 mm thick
• Hypertherm XPR 300

All our machinery

Kotec newRun10DX CNC beam drilling lineH-beams up to 1,000 x 500 mm

Used here for: A base that stays flat

Heavy profiles that need precise holes, where plasma cannot do the job: the lower structure and panel borders of a ground flare, and every bolted PEB and multi-storey frame.

• H-beams up to 1,000 x 500 mm
• Drills 3 faces in one pass
• Channels, angles and box sections

All our machinery

03 / 08

Sealed drip tray

Checker plate seal-welded to the frame with raised edges and a drain point, so a leak at a seal stays on the skid.

How is it possible at Allmarc?

HSG 12 kW fibre laser12 kW

Used here for: Sealed drip tray

• 12 kW
• Cuts up to 40 mm
• 2,500 x 8,000 mm bed

All our machinery

Deratech 8 m tandem press brake8 m bending length

Used here for: Sealed drip tray

• 8 m bending length
• Tandem technology

All our machinery

04 / 08

Pedestals the motor lines up on

Sole plates are machined after welding, so pump and motor sit on one flat plane and shaft alignment needs only a few shims on site.

How is it possible at Allmarc?

SKDX1030 CNC end-face millingMills beam and column ends square for bolted splices

Used here for: Pedestals the motor lines up on

• Mills beam and column ends square for bolted splices

All our machinery

05 / 08

Suction and discharge

Bends, flanges and spools fabricated by qualified welders, supported so that no pipe load reaches the pump nozzles.

How is it possible at Allmarc?

CNC pipe bendingCNC pipe and tube bending

Used here for: Suction and discharge

• CNC pipe and tube bending

All our machinery

Manual MIG weldingQualified welders, including 6G

Used here for: Suction and discharge

• Qualified welders, including 6G

All our machinery

06 / 08

Fittings built on

Coupling guard, instrument and junction-box stands, fitted in the works to your layout.

07 / 08

Lifts as one piece

Four padeyes sized for the full weight, so the skid goes on and off the truck without racking the piping.

How is it possible at Allmarc?

Blasting and painting boothsDust collection

Used here for: Lifts as one piece

A Level 2 coating inspector on the floor full time; weather checked and a test before every batch of paint.

• Dust collection
• 15 m paint booth for long sections
• Sa 2.5 blasting

All our machinery

08 / 08

Every piece, apart

Base, deck, pedestals, supports, piping and fittings: each one is a separate, numbered item on the drawing register and in the packing list.