Compressor, Pump & Generator Skids

01 / 08

A rotating-equipment skid

A driver, a coupling and a driven machine on one stiff base. Sizes follow your equipment datasheet; the model shows a compressor set with an access platform.

Scroll to see how it is built · drag to turn it round

02 / 08

Deep, stiff and square

Rotating machines need a base that does not flex. Heavy sections are cut, bevelled and drilled on CNC lines, then welded to a set sequence and checked for flatness before anything else goes on.

How is it possible at Allmarc?

Robotic H-beam cutting and bevelling cellBeams up to 1,000 x 500 mm

Used here for: Deep, stiff and square

• Beams up to 1,000 x 500 mm
• 12 m long, 50 mm thick
• Hypertherm XPR 300

All our machinery

Kotec newRun10DX CNC beam drilling lineH-beams up to 1,000 x 500 mm

Used here for: Deep, stiff and square

Heavy profiles that need precise holes, where plasma cannot do the job: the lower structure and panel borders of a ground flare, and every bolted PEB and multi-storey frame.

• H-beams up to 1,000 x 500 mm
• Drills 3 faces in one pass
• Channels, angles and box sections

All our machinery

Submerged-arc (SAW) welding lineFull-penetration welds on built-up sections

Used here for: Deep, stiff and square

• Full-penetration welds on built-up sections

All our machinery

03 / 08

Machined after welding

Pedestal tops are milled once the frame is welded, so driver and driven machine share one plane.

How is it possible at Allmarc?

SKDX1030 CNC end-face millingMills beam and column ends square for bolted splices

Used here for: Machined after welding

• Mills beam and column ends square for bolted splices

All our machinery

04 / 08

Deck and drip tray

Seal-welded tray and checker-plate deck, drained to one point.

05 / 08

Piping kept off the nozzles

Spools and supports fabricated together, so pipe loads go into the steel and not into the machine.

How is it possible at Allmarc?

CNC pipe bendingCNC pipe and tube bending

Used here for: Piping kept off the nozzles

• CNC pipe and tube bending

All our machinery

Manual MIG weldingQualified welders, including 6G

Used here for: Piping kept off the nozzles

• Qualified welders, including 6G

All our machinery

06 / 08

Access on the skid

A grated platform with handrail and a ladder, built as part of the skid so operators reach the top of the machine without scaffolding.

How is it possible at Allmarc?

Grip-Strut walkway automation linePunching, embossing, edge bending, shearing

Used here for: Access on the skid

• Punching, embossing, edge bending, shearing
• Single-piece planks up to 8 m

All our machinery

07 / 08

Guarded and liftable

Bolted coupling guard; four padeyes for a single lift.

08 / 08

Every piece, apart

Base, deck, pedestals, supports, piping and fittings: each one is a separate, numbered item on the drawing register and in the packing list.